The Warforge Miniature Modelling and Conversion

Arts and Crafts all over again

I'm still cutting some of these pieces out like the torpedos and the likes, but all the ships are done. I actually made two hulks, though I have no idea if that's even necessary or usable, but there you go. All of the ships are double-sided, front and back - flip them over, you see the ship facing the other way.

The easiest way to do this is just to glue the two flipped pages back-to-back with white elmers glue, let it set, and then cut the ships out. Get a very bright light to do this properly, as it will help you line the ships up. What I did was simply to coat the backside of one sheet of ships with white glue, the grabbed the reverse sheet. I held them both up to a bright light, and with it, I could see the lines through the paper and I could ensure the ships lined up right ontop of each other.

The mass of little fighta-bommerz in the bottom right corner aren't double sided simply because I don't think that's necessary - I'll be mounting them on their little bases with the picture side facing upwards.

These are going to get laminated in a few hours so that I can be certain they're held together nicely, and not going to get ruined by anything. I'm going to try and figure out a cheap and easy way of basing them - maybe washers or something, as I don't want to use all my nice flying bases up.