The Warforge Miniature Modelling and Conversion

Flipside of the hammer

I vowed to finish the other side and the glyph before I had to head back to school, so here is the 'mork' side of the hammer.

 

I understand that aesthetically it might look a bit better if the glyph were farther out from the face of the hammer, but I need to also reiterate how infinitely small they are to begin with - the only reason I was able to really cut something that size is because I used thin card. Sanding the outer ring hubs down isn't really something I care to do right now, either, because they've been riveted already. The ring is the thickness it is because when I tried making rings that were any thinner, they would fall apart when I used a pin vice to drill the rivet holes. I made about 6-7 rings before I managed to get a pair that didn't fall apart under the stress!

Still, I think it looks good all the same.