The Warforge Miniature Modelling and Conversion

Springs for legs

 

I just made a huge sort of spring-support for the main leg. The top won't be seen as it should be tucked underneath the gargant and it's skirting, but the front 'guard' plate is very bare. I think I need to slap some stray armor plating in random places on it to try and break up the huge flat surface.

The back of the leg is also a bit hollow, but I can't figure out what to put in there. Maybe stuff some additional cabling in there? It doesn't look quite complete, and this is the point where I have to break away from the drawing a bit since it's not particularly descriptive about the leg section above the ankle.